Landscape Lighting Installation Cost in Southern Maine: What Homeowners Really Pay in 2026 (And Where the Wiring Gets Complicated)
Synopsis
Landscape lighting installation cost in Southern Maine depends on more than the number of fixtures. A small front-yard path-lighting package is estimated at $1,250–$2,800, while a whole-property low-voltage system with 12–20 fixtures is estimated at $3,750–$9,400. These are planning estimates, not quotes.
One detail can change the budget and installation approach: whether your project uses a 12-volt transformer-fed system or adds hardwired 120-volt circuits. Long cable runs, frost heave, coastal conditions, ledge, and the outdoor receptacle you already have can all affect the work.
What does landscape lighting installation cost in Southern Maine?
As a national benchmark, HomeAdvisor’s June 2026 cost guide reports that most homeowners spend about $4,000, with a typical range of $1,000–$7,500. Those figures are national survey estimates, not Southern Maine prices. The estimates below apply a 25% regional adjustment to the listed national fixture and wiring ranges.
Project or item | Southern Maine planning estimate |
Small front-yard path package, 6–8 fixtures | $1,250–$2,800 |
Whole-property low-voltage system, 12–20 fixtures | $3,750–$9,400 |
Low-voltage landscape fixture, installed | $115–$190 each |
Pathway light, installed | $65–$190 each |
Floodlight, installed | $310–$1,000 each |
Uplight, installed | $125–$500 each |
Lamp post, installed | $500–$1,250 each |
Outdoor security light, installed | $440–$625 each |
Trenching and underground feed | $3.75–$6.25 per linear foot |
Add a 120-volt circuit from the panel for hardwired fixtures | $560–$1,130 and up, plus fixtures |
Diagnostic service call | $130–$200 |
Every amount in this table is an estimate, not a quote. The final price depends on your layout, equipment, existing electrical supply, landscape, and site access.
The fixture and trenching comparisons come from HomeAdvisor’s national cost data. The package ranges above are Southern Maine planning estimates for the stated project sizes, not a simple per-fixture calculation. They account for the fact that a real installation also needs a power source, suitable wiring, connections, layout work, and installation time.
The key cost decision: low-voltage or 120-volt?
Most homeowners considering low-voltage landscape lighting have a 12-volt system in mind. A transformer, sometimes called a power supply, takes power from a 120-volt source and provides lower-voltage power to the outdoor lighting cable and fixtures.
The transformer is the piece homeowners often forget to budget for. It needs to be suitable for the system and installed according to its listing and instructions. Its capacity also has to match the planned lighting load. If the nearest suitable outdoor power source is already in place, the work may be simpler. If an electrician needs to add a new circuit, that is a separate cost.
A 120-volt system is different. Hardwired fixtures need a line-voltage circuit, and adding one from the electrical panel can mean additional wiring and installation work. Our planning estimate for that circuit is $560–$1,130 and up, plus fixtures.
For older yards in South Portland, Biddeford, or Saco, we often start by looking at what outdoor power is actually available. If the only option is one tired receptacle, it is worth checking its condition and suitability before choosing a lighting layout. An existing outlet is not automatically a ready-to-use power source for a new project.

Why a 12-volt installation still needs careful wiring
Low voltage does not mean “no electrical details.” IAEI Magazine, the International Association of Electrical Inspectors, describes key requirements for low-voltage lighting systems under NEC Article 411. The article covers system voltage limits, listed equipment, isolation transformers, and other installation rules. It also explains why the cable and transformer setup matters.
One practical issue is voltage drop. On a long 12-volt run, voltage can fall along the cable. The farthest lights may appear dimmer if the cable is not sized for the length of the run and the load, not just the total fixture count.
IAEI offers typical cable-sizing guidance of 16 AWG for runs up to about 100 feet, 14 AWG up to about 150 feet, and 12 AWG up to about 200 feet, while noting that longer or heavier runs can need different sizing. These are general guidelines, not a substitute for planning the actual system. A good layout considers cable length, fixture load, and how the lighting will be divided across the transformer’s outputs.
Another installation detail is burial depth. Mike Holt’s NEC Questions & Answers explains that Table 300.5 allows 6 inches of cover for landscape lighting circuits limited to 30 volts or less when installed in Type UF or other identified cable, with 18 inches required under residential driveways and outdoor parking areas. “Cover” is measured from the top of the cable to finished grade, and direct-burial cable emerging from grade needs protection.
That minimum depth is only one part of a durable installation. In Southern Maine, freeze-thaw movement can disturb shallow cable over time, especially where the ground is repeatedly disturbed by edging, planting, or seasonal yard work. Cable routing and protection deserve attention even when the path seems straightforward.
The Southern Maine factors that can change the work
Granite and ledge: A short trench can take longer when stone or ledge interrupts the route. That is one reason a per-foot trenching estimate is only a starting point; the actual ground and path matter.
Frost heave and freeze-thaw: Direct-burial cable can shift as the ground moves. Thoughtful routing and protection help reduce the chance of damage as the seasons change.
Coastal exposure: Around Portland, South Portland, Scarborough, Old Orchard Beach, Kennebunkport, and Wells, salt air can be hard on inexpensive fixtures and connectors. Choosing appropriate outdoor components and making sound connections can help avoid premature problems.
Older outdoor power: In established neighborhoods in Saco, Biddeford, and South Portland, there may be limited outdoor power at the spot where the transformer would work best. Sometimes the location, receptacle condition, or need for a new circuit changes the plan.
Existing landscaping: Mature plants, retaining walls, stone paths, and established beds can make access slower. The installation may need to work around them rather than take the shortest route.

Permits and the 2026 Maine electrical code
Maine adopted the 2026 National Electrical Code under Electricians’ Examining Board Chapter 120, effective for installations on or after July 1, 2026. The adopted rule is available from the Maine Office of Professional and Occupational Regulation.
Permit requirements need a little care. Maine’s Title 32 §1102-C sets out the state electrical permit rule and includes exceptions for certain work, including minor repair work involving “radio and other low-voltage equipment.” It also recognizes municipal permit and inspection requirements. The Board’s electrical permit page provides additional guidance.
That means you should not assume every low-voltage yard-lighting project either does or does not need a permit. Some municipalities run their own permit and inspection programs for yard lights or low-voltage work. Requirements can depend on the work and the town. Check with your local municipality before starting; we can also help you understand what to ask.
For a related question about electrical permits, see our guide to what electrical work needs a permit in Maine.
Keep operating costs and upkeep in mind
For an efficient landscape lighting plan, consider LED fixtures and controls that suit how you use the yard. The U.S. Department of Energy’s Energy Saver guide says ENERGY STAR certified LED bulbs use up to 90% less energy than incandescent bulbs. It also points to outdoor LED pathway, step, and porch lighting, including options with automatic daylight shut-off or motion sensors.
A few practical choices can make the finished system easier to live with:
Use lighting where it helps you move safely, such as along paths and steps.
Plan fixture locations before cable is buried.
Think about where the transformer can be mounted and how it will connect to power.
Use equipment intended for the installation environment, especially in coastal areas.
Ask how the layout accounts for cable length and voltage drop.
For more seasonal home electrical planning, see our fall electrical safety checklist for Southern Maine homes. For holiday decorations, our separate holiday lighting guide covers that topic.
Frequently asked questions
What is a reasonable landscape lighting installation cost for a small yard?
A small front-yard path package with 6–8 fixtures is estimated at $1,250–$2,800 in Southern Maine. The actual estimate depends on the route, existing power, fixture selection, and whether the ground or landscaping makes installation more involved.
Is low-voltage landscape lighting safer or simpler than 120-volt lighting?
Low-voltage systems operate at a reduced voltage, but they still need suitable listed equipment, a properly selected transformer, and correctly planned wiring. A 120-volt hardwired system involves line-voltage wiring and may require a new circuit. Which approach fits depends on your goals, site, and available power.
Do I need a transformer for low-voltage landscape lighting?
A transformer or power supply is typically needed to convert the 120-volt source to the system’s lower voltage. Include it in the project plan and budget, and make sure its rating is appropriate for the system. Long cable runs also need attention to wire sizing so distant fixtures do not lose brightness.
Do I need a permit for outdoor lighting in Maine?
It depends on the work and your municipality. Maine law includes certain permit exceptions, including specified minor repairs and low-voltage equipment, but municipalities may have their own permit and inspection programs. Check with your town before work begins. Our overview of Maine electrical permits is a helpful place to start.
Can Downeast Electrical Services help with an outdoor lighting project?
Yes. We can help assess the electrical supply, discuss whether a transformer-fed system or new 120-volt circuit makes sense, and identify wiring or access issues that may affect the project. If your outdoor receptacle needs troubleshooting, our guide to electrical outlet repair costs in Maine may also be useful. You can learn more about our electrical service calls or contact us to talk through your plans.
A well-planned landscape lighting system can make paths easier to navigate and help your outdoor spaces feel welcoming after dark. The right wiring approach, transformer, and local code check can make the project smoother from the start. We’re happy to help you understand your options and plan the next step.

Comments